Not needed.

Thanks to Jim Pryor for pointing this out.

we need anchor on both sides.

Thanks to Jim Pryor for pointing this out.

Make it a bit more clear what is going on by moving initialization
of mnt_boot to same place for both cases.

And remove redundant code line.

Thanks to Jim Pryor for pointing this out.

fix case when mountpoint is a prefix of other mount. For example:

 setup-disk /d

which would also match /dev and create various bogus entries in the
generated fstab.

Thanks to Jim Pryor for pointing this out.

Thanks to Jim Pryor for pointing this out.

fixes #715

Roger Pau Monné authored Dec 30, 2011 and Natanael Copa committed Dec 30, 2011

Modified setup-interfaces to create simple bridges (works only with
one interface per bridge). Useful when setting up a Xen system, since
interfaces need to be bridged in order for guests to have networking.
Some distributions automatically create one bridge for each interface
when Xen is installed, but I think this is too aggressive.

Changes since v1:

 * Only ask to bridge interfaces if Xen Dom0 is detected

less questions

When we replace alpine_dev we should not remove the :<filesystem>

- encapsulate the alternatives in ''
- strip whitespacee from alternatives and separate with ,
- fix prompt

we encapsulate 'none' within '' everywhere else

ref #786

use 2 * total ram or maximum 1/4 of the smallest disk.
don't use more than 4G swap
if swap is smaller than 64MB then don't bother create swap at all.

ref #732